A8511KLPTR-T

Allegro MicroSystems
250-A8511KLPTR-T
A8511KLPTR-T

メーカ:

詳細:
LED照明ドライバIC BACKLIGHT DRIVER for LARGE SIZE LCDs

ライフサイクル:
NRND:
新デザインには推奨しません。
ECADモデル:
無料のライブラリローダーをダウンロードし、お使いのECADツール用にこのファイルを変換してください。ECADモデルの詳細について

在庫: 7,987

在庫:
7,987 すぐに出荷可能
7987を超える数量には、最低発注量条件が適用されます。
最小: 1   倍数: 1
ユニット価格:
¥-
合計 額:
¥-
EST関税:

価格 (JPY)

数量 ユニット価格
合計 額
¥912 ¥912
¥635.2 ¥6,352
¥592 ¥14,800
¥520 ¥52,000
¥494.4 ¥123,600
¥443.2 ¥221,600
¥374.4 ¥374,400
¥360 ¥720,000
完全リール(4000の倍数で注文)
¥358.4 ¥1,433,600

製品属性 属性値 属性の選択
Allegro MicroSystems
製品カテゴリー: LED照明ドライバIC
RoHS:  
1 Output
Boost
600 mA
TSSOP-28
21 V
8 V
REGS AND LIGHTING
- 40 C
+ 125 C
Reel
Cut Tape
ブランド: Allegro MicroSystems
水分感度: Yes
取り付け様式: SMD/SMT
製品タイプ: LED Lighting Drivers
工場パックの数量: 4000
サブカテゴリ: Driver ICs
供給電流 - 最大: 15 mA
製品が見つかりました:
類似製品を表示するには、チェックボックスを1つ以上選択します
このカテゴリーの類似製品を表示するには、上記のチェックボックスを1つ以上選択してください。
選択した属性: 0

この機能はJavaScriptを有効にすることが必要です。

CAHTS:
8542310000
USHTS:
8542310075
TARIC:
8542399000
ECCN:
EAR99

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.

A8511 Multioutput WLED/RGB Driver

Allegro MicroSystems A8511 Multioutput WLED/RGB Driver is a fully integrated high-brightness (HB) LED driver solution for medium-size backlighting displays. The flexible A8511 driver does not require external power devices to complete the backlighting design criteria. The A8511 integrates FETs for a boost converter and four 150mA current sinks, delivering a complete integrated solution at HB LED current levels. The device's LED channels allow up to 600mA sink capability when tied together. The A8511 works from a single power supply of 6.8V to 21V and withstand up to 40V. The operating frequency can be set to 2MHz, avoiding interference with the AM radio band. The integrated boost DMOS switch is rated for 40V at 3.6A. PWM dimming allows LED currents to be controlled up to a 1000:1 ratio. Additional 4:1 dimming can be achieved by using the DIM pin.