SparkFun SparkFun Accessories

SparkFun Accessories USB C is fantastic. But until we have converted all our hubs chargers and ports over to USB C this is the cable you're going to need. Supporting USB 3.1 speeds and charging up to 3A this 1 meter cable is perfect for high data rate transfers and ch

SparkFun Accessories These are very bright LEDs. The LEDs are so bright that it hurts to look directly at them. Please take a look at the pictures to get an idea of the intensity. All lenses are clear.Features:Standard Size - T1 3/4 5mm10 000mcd brightness2.4V forward dr

SparkFun Accessories This is a black plastic bezel custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. We use four 4/40-0.5" size screws matched with plastic standoffs to attach the 2x2 button pad and Simon project boards. Using two of these bezels

SparkFun Accessories Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft diffuse glow.Features:587-591nm Yellow1.8-2.2VDC Forward Voltage20mA Forward Current40 degree viewing angle100-150 MCD outputDocuments:[Datasheet](

SparkFun Accessories Here is a six pin vertical 1.0mm pitch connector. It is useful if you need something very tiny as a connection. These are not the standard JST type connectors we use on most of our boards but are actually the much smaller JST-SH type.

SparkFun Accessories DIP Sockets Solder Tail - 14-Pin 0.3

SparkFun Accessories This is a row of 40 break away headers spaced 0.1" apart with long pins on both sides. This header is especially useful when you need to connect a PCB to a solderless breadboard. Each header can be broken apart to your preference to fit custom PCBs o

SparkFun Accessories These are high quality Single Pole - Double Throw (SPDT) sealed relays. Use them to switch high voltage and/or high current devices. This relay's coil is rated up to 5VDC with a minimum switching voltage of 5V. The contacts are rated up to 5A (@25

SparkFun Accessories Transistor NPN (2N3904)

SparkFun Accessories LEDs - those blinky things. A must have for power indication pin status opto-electronic sensors and fun blinky displays.This is a very standard yellow LED. The lens is 3mm in diameter and it is diffused.Features:2.0-2.4VDC forward dropMax current

SparkFun Accessories Atmel's itty-bitty ATtiny85 8-Bit Processor. 8K of program space 6 I/O lines and 4-channel 10 bit ADC. Runs up to 20MHz with external crystal. Package can be programmed in circuit.Documents:Product CardArduino Board Definitions

SparkFun Accessories These tiny little black anodized heatsinks are perfect for cooling off small surface-mount components such as the Allegro A4983 stepper driver. Note: We ship these as singles