SparkFun ツールおよび備品

SparkFunアクセサリ This is a 10-pin header with 2mm pitch that mates with our XBee socket. It can be used for making 'dummy XBees' or anything else you want!Note: This item is sold singly not in pairs.Documents:Datasheet

SparkFunアクセサリ These nylon standoffs are 3/8" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure or just getting it up off the table. Each standoff has an outer diameter of 6mm.Sold in packs of 10. Check below for matching sc

SparkFunアクセサリ Copper tape has countless applications in electronics from creating low-profile traces for electrical components to RF-shielding and antenna-making. Copper tape is even used to join things together using solder like the stained glass on Tiffany lamp

SparkFunアクセサリ These are standard 0.1" spaced header pins that can be surface mounted for applications where through-hole pins won't work. The surface mount side of the legs are staggered for stress relief.This is a 10-Pin male header.Documents:Datasheet

SparkFunアクセサリ These are standard 0.1" spaced header pins that can be surface mounted for applications where through-hole pins won't work. The surface mount side of the legs are staggered for stress relief.This is a 6-Pin female header.Documents:Datasheet

SparkFunアクセサリ These are standard 0.1" spaced header pins that can be through-hole mounted. This header connects perfectly with most 8-pin male headers.This is a 8-Pin female header.Documents:Datasheet

SparkFunアクセサリ PCB mount clip to hold a AAA battery. Sold in single units you'll need two for each battery. These work great for small low power applications that need a battery to run. Low cost and easy to use!Documents:Datasheet

SparkFunアクセサリ This is a simple 2x8 male PTH header. This header is that you will find commonly used to interface with a basic 8x2 character LCDs. Each pin has a spacing of 0.1" in between each other.Documents:Datasheet

SparkFunアクセサリ Adjustable Parts Box

SparkFunアクセサリ Jumper wires are awesome. Just a little bit of stranded core wire with a nice solid pin connector on either end. They have the flexibility of stranded wire but will fit directly into breadboards and female pin headers. These are 6 inch long 26 AWG j

SparkFunアクセサリ This 3xAA battery holder puts a nice finishing touch on your battery powered project. This holder features a removable sliding cover as well as an ON/OFF switch that can be used to control power to your project. The 6" ( 150mm) cable has been termin

SparkFunアクセサリ The RTK Facet Carrying Case helps protect your valuable high-precision GNSS receiver from the harsh elements of the field. Custom slots are molded into the case for the RTK Facet receiver a 915MHz radio + antenna as well as a large open slot for po