SparkFun SparkFunアクセサリ

SparkFunアクセサリ This simple breakout board makes it easy to use our LED tactile switches in a breadboard or your next project.Note: Populate the board according to the polarity of the LED on the switch. The markings for the switch are irrelevant and can be reversed

SparkFunアクセサリ Load Sensor Combinator Ver. 1.1

SparkFunアクセサリ SSOP to DIP Adapter 16-pin

SparkFunアクセサリ Buttons are an easy and tactile way to interface with your project but why deal with debouncing polling and wiring up pull-up resistors? The SparkFun Qwiic Button Breakout simplifies all those worries away into an easy-to-use I2C device. Utilizing

SparkFunアクセサリ Buttons are an easy tactile way to interact with your project but why deal with debouncing polling and wiring up pull-up resistors? The Qwiic Button with a built-in green LED simplifies all those worries into an easy-to-use I2C device. Utilizin

SparkFunアクセサリ This is an interface cable for the Bus Pirate designed to connect to its 2x5 I/O header. The cable's connector is composed of two rows of five 0.1" spaced pins; it's also polarized as is the mating connector on-board the Bus Pirate so you can only

SparkFunアクセサリ Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.This is a 15ft. length of 6-wire ribbon cable. Check the

SparkFunアクセサリ USB OTG Cable- Fem. A to Micro B - 5in

SparkFunアクセサリ USB-C is fantastic. What makes this cable even better is that one of the features we love so much about USB-C has been replicated to the USB-A 2.0 plug! These cables have minor yet genius modifications that allow them to be plugged into their ports

SparkFunアクセサリ The MyoWare 2.0 Reference Cable is meant as an extension for the MyoWare 2.0 Muscle Sensor's reference pin. You will just need to insert the pin into its housing and place a biomedical sensor pad into the electrode snap. When ready stick the refer

SparkFunアクセサリ This a simple breakout board for the button pads. Each LED and button is brought out to the side connectors. The connectors are soldered to the back side of the PCB. We recommend trimming the connector leads on the button side as short as possible to

SparkFunアクセサリ This is a very common 0.1uF capacitor. Used on all sorts of applications to decouple ICs from power supplies. 0.1" spaced leads make this a perfect candidate for breadboarding and perf boarding. Rated at 50V.