SparkFun Electronics SparkFun Accessories

SparkFun Accessories Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.This is a 3ft. length of 10-wire ribbon cable. Check the

SparkFun Accessories This is a 10-pack of wires that are pre-terminated with an alligator clip on one end and a female header on the other. Alligator clips are a staple item for any workbench or makerspace and with these cables you will be able to easily incorporate tho

SparkFun Accessories USB-C is fantastic. What makes this cable even better is that one of the features we love so much about USB-C has been replicated to the USB-A 2.0 plug! These cables have minor yet genius modifications that allow them to be plugged into their ports

SparkFun Accessories This a simple breakout board for the button pads. Each LED and button is brought out to the side connectors. The connectors are soldered to the back side of the PCB. We recommend trimming the connector leads on the button side as short as possible to

SparkFun Accessories There is nothing quite like the satisfying mechanical thunk of a real arcade button. This 35mm blue concave push button is built specifically to recreate that exact tactile experience for your custom cabinets and interactive projects. Instead of a s

SparkFun Accessories There is nothing quite like the satisfying mechanical thunk of a real arcade button. This 35mm black concave push button is built specifically to recreate that exact tactile experience for your custom cabinets and interactive projects. Instead of a

SparkFun Accessories This is a resistive analog joystick very similar to those found on the PSP1000. These compact joysticks are different in that they have a very interesting 'slide' feeling.For wiring this part if you look at the device from the bottom the pin out go

SparkFun Accessories This Clear Plastic Knob press-fits onto standard 6mm shafts and allows RGB light to shine through for your custom illuminated interfaces. The outer diameter of this knob is tapered with 14.5mm at the top and 15mm at its base and features two notche

SparkFun Accessories If you ever find yourself connecting handfuls of resistors to the ground bus of your breadboard you may consider these SIL-packaged resistors as a time-saving alternative. This Singe In-Line component is actually 5 individual 330 Ohm resistors that

SparkFun Accessories LED - 5mm Cycling RGB (slow)

SparkFun Accessories Do you need that extra push over the cliff? The Small sized GTE (Goes To Eleven) Knob can fit onto potentiometers with a 6mm wide shaft thanks to a brass insert with a set screw. Unfortunately this knob does not play well with 1/4" shafts (nobody li

SparkFun Accessories We know this looks like a lot of our other LEDs but it's not! This is a PTH Addressable RGB LED with a WS2812 control IC built right into the LED. This PTH version is incredibly similar to its SMD cousin except it is a lot simpler to solder into yo