TLC5940QPWPREP

Texas Instruments
595-TLC5940QPWPREP
TLC5940QPWPREP

メーカ:

詳細:
LED照明ドライバIC EP 16Ch LED Drvr

ECADモデル:
無料のライブラリローダーをダウンロードし、お使いのECADツール用にこのファイルを変換してください。ECADモデルの詳細について

在庫: 1,917

在庫:
1,917 すぐに出荷可能
工場リードタイム:
6 週間 表示されている時間を超える工場生産予定時間。
1917を超える数量には、最低発注量条件が適用されます。
最小: 1   倍数: 1
ユニット価格:
¥-
合計 額:
¥-
EST関税:
パッケージング:
完全リール(2000の倍数で注文)

価格 (JPY)

数量 ユニット価格
合計 額
カットテープ/ MouseReel™
¥1,185.6 ¥1,186
¥1,035.2 ¥10,352
¥960 ¥24,000
¥876.8 ¥87,680
¥836.8 ¥209,200
¥812.8 ¥406,400
¥793.6 ¥793,600
完全リール(2000の倍数で注文)
¥772.8 ¥1,545,600
† ¥750 MouseReel™の料金が追加され、ショッピングカートに加算されます。すべてのMouseReel™の注文は、キャンセルおよび返品できません。

製品属性 属性値 属性の選択
Texas Instruments
製品カテゴリー: LED照明ドライバIC
RoHS:  
16 Output
Boost
120 mA
HTSSOP-28
5.5 V
3 V
30 MHz
17 V
TLC5940
- 40 C
+ 125 C
Dot Correction, LED Open Detection, PWM Control
Reel
Cut Tape
MouseReel
ブランド: Texas Instruments
入力電圧: 3 V to 5.5 V
水分感度: Yes
取り付け様式: SMD/SMT
チャンネル数: 16 Channel
製品タイプ: LED Lighting Drivers
工場パックの数量: 2000
サブカテゴリ: Driver ICs
供給電流 - 最大: 12 mA
別の部品番号: V62/10610-01XE
単位重量: 120 mg
製品が見つかりました:
類似製品を表示するには、チェックボックスを1つ以上選択します
このカテゴリーの類似製品を表示するには、上記のチェックボックスを1つ以上選択してください。
選択した属性: 0

                        
TIs Enhanced Product line is a commercial of-the-shelf (COTS)
solution with the following key benefits:

Fabrication and assembly controlled baseline
No use of Pure Sn bond pads, balls or Cu bond wires
DLA Vendor Items Drawings (VID or V62) part numbers that
eliminate the need for source controlled drawings
Extended product change notification (PCN)
Extended temperature performance (typically -55C to +125C
or customer specified)
Standalone data sheet
Qualification and Reliability reports
Extended HAST testing
Product traceability
Long product life cycles

Please contact a Mouser Technical Sales Representative for
further information.

5-0516-01

この機能はJavaScriptを有効にすることが必要です。

JPHTS:
8542390990
CNHTS:
8542319090
CAHTS:
8542390000
USHTS:
8542390090
TARIC:
8542399000
MXHTS:
85423999
ECCN:
EAR99

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.