Analog Devices Inc. ADG5208F/ADG5209F障害保護マルチプレクサ
Analog Devices ADG5208FとADG5209Fは、8:1およびデュアル4:1アナログマルチプレクサで、最大−55Vおよび+55Vの過電圧保護を備えています。ADG5208Fは8つの入力のうちの1つを共通出力に切り替え、ADG5209Fは4つの差動入力のうちの1つを共通差動出力に切り替えます。両デバイスのEN入力が、デバイスを有効または無効にします。オンの場合、各チャンネルは両方向に同じように動作し、電源までの入力信号範囲を提供します。デジタル入力は、動作電源電圧範囲全体において3Vのロジック入力に対応します。電源が供給されていない場合、スイッチはオフのままになり、スイッチ入力は障害保護を目的として高インピーダンス状態で行われます。通常の動作条件では、任意のSxピンでのアナログ入力信号レベルが、VDDまたはVSSを閾値電圧VTだけ超過する場合、スイッチはオフになりドレイン端子は超過した供給電圧に引かれます。ADG5208F and ADG5209Fでは、電源がオン、オフのどちらの条件においても、接地に対して最大+55Vまたは−55Vまでの入力信号レベルはブロックされます。低キャパシタンスおよびこれらのスイッチの電荷注入により、ADG5208FおよびADG5209Fは低グリッチと高速セトリングを必要とするデータ収集とサンプルとホールドアプリケーション用の理想的なソリューションになります。When power supplies are absent, the switch remains in the off condition and the switch inputs are in a high impedance state for fault protection. Under normal operating conditions, if the analog input signal levels on any Sx pin exceeds VDD or VSS by a threshold voltage, VT, the switch turns off and the drain pin is pulled to the supply voltage that was exceeded. ADG5208F and ADG5209F blocks input signal levels up to +55V or −55V relative to the ground in both the powered and unpowered conditions.
The low capacitance and charge injection of the ADG5208F and ADG5209F switches make them ideal solutions for data acquisition and sample-and-hold applications, where low glitches and fast settling are required.
特徴
- Overvoltage protection up to −55V and +55V
- Power-off protection up to −55V and +55V
- Overvoltage detection on source pins
- Low charge injection (QINJ): −0.4pC
- Low on capacitance
- ADG5208F: 20pF
- ADG5209F: 14pF
- Latch-up immune under any circumstance
- Known state without digital inputs present
- VSS to VDD analog signal range
- ±5V to ±22V dual supply operation
- 8V to 44V single-supply operation
- Fully specified at ±15V, ±20V, +12V, and +36V
アプリケーション
- Analog input/output modules
- Process control/distributed control systems
- Data acquisition
- Instrumentation
- Avionics
- Automatic test equipment
- Communication systems
- Relay replacement
