PCA9955BTWJ

NXP Semiconductors
771-PCA9955BTWJ
PCA9955BTWJ

メーカ:

詳細:
LED照明ドライバIC I2c 16 Channel LED Driver

ECADモデル:
無料のライブラリローダーをダウンロードし、お使いのECADツール用にこのファイルを変換してください。ECADモデルの詳細について

在庫: 15,748

在庫:
15,748 すぐに出荷可能
工場リードタイム:
16 週間 表示されている時間を超える工場生産予定時間。
最小: 1   倍数: 1
ユニット価格:
¥-
合計 額:
¥-
EST関税:
パッケージング:
完全リール(2500の倍数で注文)

価格 (JPY)

数量 ユニット価格
合計 額
カットテープ/ MouseReel™
¥382.4 ¥382
¥284.8 ¥2,848
¥259.2 ¥6,480
¥232 ¥23,200
¥219.2 ¥54,800
¥211.2 ¥105,600
¥209.6 ¥209,600
完全リール(2500の倍数で注文)
¥196.8 ¥492,000
¥192 ¥960,000
† ¥750 MouseReel™の料金が追加され、ショッピングカートに加算されます。すべてのMouseReel™の注文は、キャンセルおよび返品できません。

製品属性 属性値 属性の選択
NXP
製品カテゴリー: LED照明ドライバIC
RoHS:  
16 Output
Boost, Buck
65 mA
HTSSOP-28
5.5 V
3 V
8 MHz
Adjustable
PCA9955BTW
- 40 C
+ 85 C
I2C Control
Reel
Cut Tape
MouseReel
ブランド: NXP Semiconductors
組立国: Not Available
拡散国: Not Available
原産国: TH
入力電圧: 3 V to 5.5 V
取り付け様式: SMD/SMT
チャンネル数: 16 Channel
出力タイプ: Constant Current
Pd - 電力損失: 3.2 W
製品: LED Drivers
製品タイプ: LED Lighting Drivers
工場パックの数量: 2500
サブカテゴリ: Driver ICs
供給電流 - 最大: 21 mA
タイプ: LED Lighting Driver
別の部品番号: 935306128118
単位重量: 104.052 mg
製品が見つかりました:
類似製品を表示するには、チェックボックスを1つ以上選択します
このカテゴリーの類似製品を表示するには、上記のチェックボックスを1つ以上選択してください。
選択した属性: 0

JPHTS:
854239099
CNHTS:
8542399000
CAHTS:
8542390000
USHTS:
8542390090
TARIC:
8542399000
MXHTS:
8542399999
ECCN:
EAR99

PCA9955 16-channel Constant Current LED Driver

NXP Semiconductor PCA9955 LED Drivers are I2C controlled 16-channel constant current drivers designed for dimming and blinking 57mA Red/Green/Blue/Amber (RGBA) LEDs in amusement products. Each channel has an 8-bit resolution (256 steps) 31.25kHz PWM controller with a duty cycle that is adjustable between 0% to 99.6%. This feature allows each LED to be set to a specific brightness. An additional 8-bit resolution (256 steps) group PWM controller has both a fixed frequency and an adjustable frequency. This additional controller is used to either dim or blink all the LEDs with the same value.

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.